You can choose to hide or display the entire statusД«ar. The Simulation status is part of the status bar Simulation IndicatorsД¬onstruct the scope object and before you first run the Time and the values on the time axis in allДisplays, except the bottom ones in each column of displays, set thisД«ehavior differs from the Simulink В® Scope (Simulink) block, whichДЄlways shows the values but never shows a label on the x-axis.ДЇor more information, see Configure the Time Scope Properties. Time axis, set the Show time-axis labels parameter To hide both the word Time and the values on the None, then Time Scope shows only the word Milliseconds, microseconds, minutes, days, etc.

Time Span) and displays in metric units such as By default, this parameter is set to Metric (based on

Time tab of the Configuration Properties dialogД«ox. The Time Scope sets the time units using the value of the Of those values with the value of the Time span parameter. If you specify a vector of values for the TimeДisplay offset parameter, the scope sets the maximum time-axis limit by summing the largest Limit by summing the value of Time display offset parameter with the value of the Maximum time-axis limit - The Time Scope sets the maximum time-axis Those values to set the minimum time-axis limit. Values for the Time display offset parameter, the scope uses the smallest of Main tab of the Configuration Properties dialog box. Limit using the value of the Time display offset parameter on the Minimum time-axis limit - The Time Scope sets the minimum time-axis

Scopebox required hardware